Sport Bonnet(Hood) var №2 "Agressive Sport" for Honda Accord 8(VIII) / Acura TSX

Product is in stock

Vehicle:  Honda / Acura
Model:  Accord 8(VIII) CU1, CU2, CW1, CW2 / TSX CU2, CW2
Years:  2008, 2009, 2010, 2011, 2012, 2013, 2014
Facelift:  Compatible with all years
Comleteness:  Sport Bonnet(Hood) - 1 pc.
Dimensions:  1480mm*1300mm*140mm
Weight (grams):  12000 gram
Material:  Highqualiti Fiberglass
Installation time:  30-60 min
Additional services:
Add to Cart

Lightweight hood "Agressive Sport" for Honda Accord VIII Var. No. 2 (with a cut through central air intake)

• Brand new

• Produced of quality-made FRP material

• No need of additional refinement

• Fit and quality  guaranteed 

• Easy to  install (please see installation instruction on our description). The item does not require any modifications on the car. It fits perfectly.

Color: Unpainted fiberglass, paint in any color is possible at an additional cost.

For your recomendation regarding painting:

 Before painting the parts apply it on the car to make sure it perfectly fits. There have been incidents at body shops damaging the plastic part with wrong type of paint and high temperature drying. The drying temperature must not exceed 60°С  (140F).

Our items require only conventional automotive painting technique:  sanding, priming, painting  and clear coating.

Mass-produced parts may have small surface scratches that are easily removed during prep work.

We mostly make painting of our parts at the official dealers. The painting process is accomplished according to a code of painting. The “base colour” is blended according to painting code. In most cases of our parts painting process the color matching on fuel cap is not needed.  The parts match in 95% of orders, sometimes having slight differences in vehicle dashes. But also there is low percent when the base color differs distinctively from vehicle dash. If you have doubts in this case of colouring on painting code please consult our managers or make color matching on fuel cap of a vehicle.
Unscrew the two screws on each of the hood hinges and remove the factory hood, then tighten a new hood, while tightening the bolts, it must be pushed forward on both sides. To do this, you definitely need an assistant with a second pair of hands. After installing the new hood, if necessary, adjust the hood clearances. To set the side gaps, you need to use the adjustment of the hood hinges, and for this it will be necessary to remove both plastic linings of the wings in order to get to the necessary bolts. It may also be necessary to adjust the height of the hood lock and the rubber good stays. All these adjustments are shown in the figure below:

Important note: if the hood does not close tightly, then do not haste to adjust the hood lock. Start by adjusting the hinge of the hood itself, as often it is set higher than on the production hood. Just measure with a ruler how long the hinge stands out on your factory hood, and then compare it with how much it stands out on a new one.
We express our gratitude to our client and friend Vladimir for the installation instructions predentd. link to drive2
Have a question? Chat with a specialist
Payment You can purchase goods from us
Delivery We deliver goods worldwide
Guarantees Return of goods within 14 days

With this product buy: